UNIFLEX-Hydraulik - 17 - www.uniflex.de
Chapter 5
Crimping
Quick die change QDC 239.5
Insert the crimp dies 239 / 239L in the machine
Take the crimp dies 239 / 239L out of the machine
To take out the crimp dies do the above in reverse order.
Attention:
Holding pins or crimp dies will be damaged if they do not slide in the bore holes of the base or
intermediate dies.
Open the crimp tool
completely.
If applicable set the crimp
micrometer to 0,0 mm. Put the
UNIMATIControl B / E in the
die changing position.
Insert the eight pins in the front
of the crimp dies and turn
towards the left. Take the tool
and the dies out of the Quick
Die Storage.
Take out the QDC 239.5
and check the tight fit of
the crimp dies.
Close the crimp tool and make
sure that the holding pins slide
smoothly in the bore hole in
base or intermediate dies and
make sure that they lock in.
Hold the QDC 239.5 in the
centre of the crimp tool.