13
microMIND V2 - Installation Guide
Software Version
The current firmware version of the microMIND V2.
Network
Shows the IP address of the microMIND V2, the Subnet, Gateway address and whether
it is configured manually or via DHCP.
Last ID (raw)
Shows the last ID of a read out authentication card without code conversion (raw data).
Name
You can change the default name microMIND V2 for an easier identification of the device
itself, for example the name of the associated printer.
Connect to Server IP only
Here you can limit the communication between a certain uniFLOW Server and the
microMIND V2. This means that this microMIND V2 only "talks" to the entered uniFLOW
Server IP address and to no other computer in the network.
Restrict HTTP Access to IP
Only the computer with the IP address entered here is able to open the websites of the
microMIND V2. The uniFLOW Server will always have access to the microMIND V2
independent of the settings here. If left blank, there is no access limitation.
Note that HTTP port 80 must not be blocked by a firewall to reach the
microMIND V2 website.
The
USB Device
site gives information about the following:
If it is connected to a USB Device, it shows which device is connected (see example
screenshot below).
