Compliance and Disposal Notes
FCC Compliance Notes (for USA)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
▪ Reorient or relocate the receiving antenna.
▪
▪ Increase the separation between the equipment and receiver.
▪
▪ Connect the equipment to an outlet on a circuit different from that to which the
▪
receiver is connected.
▪ Consult the dealer or an experienced radio/TV technician for help.
▪
IC Compliance Notes (for Canada)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
For models with integrated RFID functionality:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
User Information on Disposal of Waste Electrical & Electronic Equipment
(WEEE)
The WEEE symbol on the product and/or accompanying documents means that used
electrical and electronic equipment should not be mixed with general household waste.
For proper treatment, recovery, and recycling, please take this product to designated
collection points, in accordance with your national legislation and the Directive
2012/19/EU.
The following symbol is only valid in the European Union (EU).
23
Specifications
9.1
Summary of Contents for microMIND V2
