S e c t i o n 3 – S y s t e m P r o g r a m m i n g
45
Default
The door relay closed-contact delay is 5 seconds.
Extensions 23 and 24 are set as normal extension operation only (212 only).
Set door relay contact to close for 5 seconds
Set door relay contact to close for 10 seconds
Set extension 23 as door phone (212 only)
Set extension 24 as door phone (212 only)
Reset extension 23 and 24 to regular extension operation (212 only)
DTMF Extensions
DTMF extensions will allow only DTMF signalling. The time window for recall pulses is
programmable for DTMF extensions to prevent problems with hook switch bounce.
For all extensions programmed as DTMF only a recall signal is recognised if the pulse length falls
between a certain programmable period.
Default
Extensions are compatible with both pulse and DTMF signalling. The time window for DTMF only
extensions is between 40 and 160 ms for Australia or 40 and 600ms for New Zealand.
Set an extension as DTMF only
SYSTEM SETTINGS
Miscellaneous
DTMF phone
DTMF On
Reset an extension from DTMF only
SYSTEM SETTINGS
Miscellaneous
DTMF phone
DTMF Off
Set default recall time window (40 – 160/600 ms)
Set programmable time window
Exchange Line Assignment (Bundle Splitting)
This feature allows extensions outgoing calls on certain exchange lines only. There are two levels of
assignment; extensions may be barred completely from dialling out on certain exchange lines, or they
may be allowed to access lines by dialling the line select code ‘9 line no.’, but blocked using the
automatic ‘0’ line access code. For example, a fax extension could be programmed to dial out on a
dedicated fax line only. The default is that all extensions can access all exchange lines. An extension
dialling the ‘0’ line access code the system will access the next free line that is assigned to it, from line
1 to line 6.
Default
All extensions are able to make and receive calls on all exchange lines.
Step 1
: Set which lines can be accessed by extensions.
Allow an extension to use an exchange line (206 only)
SYSTEM SETTINGS
Bundle Splitting
Assign Exch to Ext
Allow an extension to use an exchange line (208/212
only)
SYSTEM SETTINGS
Bundle Splitting
Assign Exch to Ext
Prevent an extension using an exchange line (206 only)
SYSTEM SETTINGS
Bundle Splitting
Cancel Exch to Ext
Prevent an extension using an exchange line (208/212
only)
SYSTEM SETTINGS
Bundle Splitting
Cancel Exch to Ext
PIN
ext1, ext2,… ext n
Key
window =
0 default 40 – 160/600ms
1 for 60 – 160/600ms
2 for 70 – 160/600ms
3 for 80 – 160/600ms
4 for 90 - 160/600ms
5 for 100 - 160/600ms
PIN
ext1, ext2,… ext n
window
PIN
line
ext1, ext2,… ext n
Key
line =
0 for all exch lines
1 - 6 for single exch. line
PIN
line
ext1, ext2,… ext n
PIN
line
ext1, ext2,… ext n
PIN
line
ext1, ext2,… ext n
