12
After making sure that the winch operates properly by using the manual console, you can
test the winch with a remote control.
If the winch is not responding, your remote control is not suitable. In this case, replace the
remote control or put the winch into the classic mode. To do this, follow the procedure
below.
Classic mode
SMART 3in1
SMART 3in1 / TERRA
The unwinding device
activates after 1.5 seconds.
The unwinding device is
activated with an impulse
–
no
delay
Unwinding device turns on
with a pulse
–
without delay
We can see on the transmitter
whether the unwinding device
is active
To start unwinding the pulling
rope with the unwinding
device:
Hold the unwinding button for
at least 1.5 seconds.
To switch off the unwinding
device:
Release the unwinding
button.
To switch the unwinding
device back on:
Hold the unwinding button for
at least 1.5 seconds.
To switch on the unwinding of
the pulling rope:
Hold the unwinding button for
at least 1 second:
This activates the unwinding
process
without
the unwinding
device.
To switch on the unwinding
device:
Press the unwinding button.
To switch off the unwinding
device:
Press the unwinding button.
To switch off the unwinding of
the pulling rope:
Press the pulling button.
Switching on unwinding of wire
rope:
Hold the unwinding switch for
at least 1 second.
Unwinding function turns on
without
unwinding device.
Switching on the unwinding
device
:
Push the unwinding switch to
direction of unwinding
–
permanently.
Switching off the unwinding
device
:
Turn off the unwinding switch -
permanently
Switching off unwinding of wire
rope:
Press the pulling function
button.
med dvema intervaloma
vklopa in izklopa odvijalne
naprave vedno držite gumb
vsaj 1,5 sekunde.
odvijalna naprava se vključi v
trenutku ko pritisnete gumb za
odvijanje.
The unwinding device is
activated the moment you
press the unwinding function
button.
