UIC680 Programmer’s Manual
UDN PM090-C2 Rev. 2.3
9 (39H) – JCOP31
0 (30H) - Not MIFARE card or Not supported card
’*’ - No card response or No power on the antenna
NOTE
This command is only available after users successfully activate the
MIFARE cards (after the ‘f’ or ‘X’ command).
•
y (79H) – Send DESELECT command
COMMENT
Sends ISO 14443 layer 4 DESELECT command to the card.
Response ‘^’
-
Acknowledgement
‘*’ - No card response or No power on the antenna
•
Z (5AH) – I/O to contactless CPU card with APDU format
COMMENT
The command is used to pass an APDU to the card where both data and
an ISO status are expected in the response.
Z[APDU, variant, 262 bytes max]
[APDU] - Binary hex(00h to FFh)
If successful, the data from the ICC and the two bytes SW1/SW2 ISO 7816-4 response are
returned.
If unsuccessful, reader transmits '*'.
APDU Command Structure
CLA INS P1 P2
P3
Lc or Le
Data
(If Lc present)
APDU Response Structure
Data
(optional)
SW1 SW2
•
z (7AH) – I/O to contactless card for block data exchange
COMMENT
The command is used to pass a block data to a card.
z[CRC mode, 1 byte][Wait time, 4 bytes][Block data, 384 bytes max]
5-21
