SAS to SAS/SATA JBOD Subsystem
26
User Manual
7.
Turn the disk tray upside down. Align the four screw holes of the SATA disk
drive in the four
Hole B
of the disk tray. To secure the disk drive into the disk
tray, tighten four screws on these holes of the disk tray. Note in the picture
below where the screws should be placed in the disk tray holes.
NOTE: The mounting hole locations of the new 6-disk are
different from the existing drives.
3-, 4-, and 5-disk
6-disk
Four bottom mounting holes of drive
Four bottom mounting holes of drive
NOTE: All the disk tray holes are labelled accordingly.
8.
Insert the disk tray into the subsystem.
Tray Hole B
Tray Hole B
Different screw positions: Comparing 6-Disk Drive to
existing Drive