10
Installation of the telephone
See also overview on page 2.
Desk Installation
By mounting the stand on the telephone using the long or short end
you can select between 16° and 51° tilt angle:
1.
Place the phone upside down on a soft surface and remove all
cables from the phone except the handset cord
d
.
2.
Insert the stand along the bars on the base of the telephone as
shown.
3.
Slide the stand to the stop at the left until it locks into place.
4.
If your LAN does not have PoE (Power over Ethernet; ask your
administrator), then you need to use a power supply connected
to the power jack
.
5.
Connect the LAN cable with the jack
on the base of the
telephone and the wall jack.
Wall Installation
http://wiki.unify.com
.
Optional Connections
If desired, you can connect further devices to your phone (see also
overview on page 2):
Connection to PC
If further settings are required for correct operation of the telephone,
please contact your administrator.
long end: 16°
short end: 51°
B
C
A
KBA.book Page 10 Wednesday, November 7, 2018 2:12 PM
Summary of Contents for OpenScape Desk Phone CP100
Page 2: ...2 1 2 7 8 4 10 11 12 13 D A B C 6 5 3 9 KBA book Page 2 Wednesday November 7 2018 2 12 PM...
Page 32: ...32 This page intentionally left blank KBA book Page 32 Wednesday November 7 2018 2 12 PM...
Page 34: ...34 This page intentionally left blank KBA book Page 34 Wednesday November 7 2018 2 12 PM...
Page 35: ...35 This page intentionally left blank KBA book Page 35 Wednesday November 7 2018 2 12 PM...
