beispiele.fm
A31003-C1000-M102-5-76A9, 09/2017
OpenScape Desk Phone CP200/CP205/CP400/CP600 HFA, Administration Manual
175
Examples and HowTos
An LLDP-Med Example
4.2.4
Configure LDAP Access
To enter the access data using the WBM, take the following steps:
1.
Navigate to
Local Functions
> Directory Settings.
2.
Enter the following parameters:
•
Server address
(IP address or hostname of the LDAP server)
•
Server port
(port used by the LDAP, typically 389)
•
Authentication
(authentication method for the connection to the LDAP server)
•
User name
(only required if simple authentication is selected);
Password
(relating to
the user name).
3.
Press
Submit
.
4.3
An LLDP-Med Example
The following example illustrates the mode of operation of LLDP-MED. In order to evoke a re-
action from LLDP-MED, the LAN switch has been set to auto-negotiation, whereas the phone’s
LAN port (see Section 3.2.1, “LAN Port Settings”) is set to 100Mbit/s, hence a fixed value. This
configuration error is detected and displayed by LLDPMED. Please note the status of MAC_Phy
config displayed in the local phone´s Admin menu.
1.
Log in as administrator on the local phone´s
Admin
menu.
2.
In the
Admin menu, navigate to Network > LLDP-MED Operation
using the navigation
keys, and click OK.
3.
In the LLDP-MED Operation submenu (see
LLDP-MED Operation
), navigate to MAC_Phy
config and note the status displayed:
4.
Select the MAC_Phy config submenu by pressing OK and navigate to the parameters dis-
played by using the navigation keys.
The following status is displayed for the MAC_Phy config parameters:
AutoSet enabled = Incompatible
MAU = Incompatible
Directory settings
LDAP Server address
LDAP Server port
Authentication
Anonymous
389
User Name
Password
Submit
Reset
Search trigger timeout
3
