Administration
A31003-C1000-M102-5-76A9, 09/2017
52
OpenScape Desk Phone CP200/CP205/CP400/CP600 HFA, Administration Manual
administration.fm
IP Network Parameters
3.3
IP Network Parameters
3.3.1
Quality of Service (QoS)
The QoS technology based on layer 2 and the two QoS technologies Diffserv and TOS/IP Pre-
cedence based on layer 3 are allowing the VoIP application to request and receive predictable
service levels in terms of data throughput capacity (bandwidth), latency variations (jitter), and
delay.
3.3.1.1
Layer 2 / 802.1p
QoS on layer 2 is using 3 Bits in the 802.1q/p 4-Byte VLAN tag which has to be added in the
Ethernet header.
The CoS (class of service) value can be set from 0 to 7. 7 is describing the highest priority and
is reserved for network management. 5 is used for voice (RTP-streams) by default. 3 is used
for signaling by default.
Data required
•
Layer 2
: Activates or deactivates QoS on layer 2.
Value range: "Yes", "No"
Default: "Yes"
•
Layer 2 voice
: Sets the CoS (Class of Service) value for voice data (RTP streams).
Value range: 0-7
Default: 5
•
Layer 2 signalling
: Sets the CoS (Class of Service) value for signaling.
Value range: 0-7
Default: 3
•
Layer 2 default
: Sets the default CoS (Class of Service) value.
Value range: 0-7
Default: 0
>
Layer 2 and 3 QoS for voice transmission can be set via LLDP-MED (see LLDP-
MED). If so, the value can not be changed by any other interface.
Three Bits Used for CoS
(User Priority)
PREAM.
SFD
DA
SA
TAG
4 Bytes
PT
DATA
FCS
