TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
48
6. Handset Configuration
Table 2. Call prio vs PTT prio
Table 3. Call prio vs Message prio
•
Show and indicate messages in charger
Defines if incoming messages are shown and indicated by a beep when the
handset is placed in the charger.
NOTE: This affects all messages and priority levels (PTT invitation received as a
message and messages with breakthrough such as high/alarm priority) including
remote call setup. Messages are stored in the Messaging inbox.
TIP: If you only want to silence messages without breakthrough (low/normal
priority), set the Sound off parameter instead (in Device > Settings > In charger
action > Sound off).
Settings > Display
•
Rotate display text
Defines if incoming messages are displayed upside down. This can be useful if you
wear the handset in a belt and want to read the message without rotating the
handset. When pressing any key, the messages are displayed in the normal way.
NOTE: This setting also affects how incoming calls are displayed.
6.8.1
Configure Message Alerts with Beep Codes
The handset can map beep codes sent from a system/an application to different
message alerts. There are several ways to treat the beep codes:
TIP: To configure the same message alert for a group, make the settings in the
WinPDM in Profiles > Normal/Profile X > Message alert. Save the settings as a
template and add it to desired handsets.
10
1
Yes, immediately since the PTT priority is
set to 1 and also is higher than Call priority.
10
2
Yes, after 10 seconds since the PTT priority
is higher than Call priority.
a. PTT invitation received as incoming call has always priority 6, while PTT invitation received as
message can have priority 1 - 9 depending on configuration.
Call prio
Displayed Message
(prio)
Call information suppressed?
0
1
No, since this call priority setting overrides
all messages regardless of priority.
7
6
Yes, since the priority of the displayed
message is higher than the incoming call.
6
6
Yes, since the message is considered as
most important when the priority is equal.
1
3
No, since the priority of the incoming call is
higher than the displayed message.
10
1
Yes, the call information is always
suppressed regardless of the message
priority.
