14
2.4 Password
2.4.1
Access to service levels by password
Depending on password (service or OEM), different parameters are visible.
"Service" parameters, as per the actuator curves and the set-point values, are password protected. The operator must logon using the "
9876
" password.
"User" level doesn't need a password.
If a password shall be entered, line Enter password is selected by means of decrementing (pointer points to the first character of that line) and then
finally selected by pressing Enter.
Then, the pointer jumps to the first position of the password entry line. Now, through incrementing or decrementing, a character (digit or letter) can be
selected. A character is confirmed by pressing Enter. If a wrong entry has been made, the last character can be edited again by pressing Esc.
The other password positions can be selected, edited and entered in a similar way. Hence, when making an entry, only 1 character is visible. When the
last character of the password is reached, the entry is to be confirmed by pressing Enter.
Display before the first password character is entered:
Enter Password
:
* * * * * * * *
The example displays when entering the third password character:
Enter Password
:
* *
S
* * * * *
If the check of the password entered is positive, the change to the next menu level takes place. Otherwise, the display returns to the main menu level.
To go back to the main menu, press “Esc” until the first level menu is reached, then press the “right arrow” , un till the first item is reached,
then press “ Enter “ twice.
2.4.2 Password
Logout
To avoid customer changes on parameter settings and consequently changes in regulation, the password must be logged out. The “password logout”
functions on the first level menu: press to choose “PW Logout” then press “Enter“.
Note:
if no key is pressed within a settable period, the password is deactivated automatically.
Note:
if a power supply drop occurs to the unit, the password will be automatically deactivated.
2.4.3 Changing
password.
Following the below route access to the programming levels of the menu by means the Esc
1st level
2nd level
3rd level
4th level
5th level
6th level
Description
Updating
Password
To
change
password
ServicePassword
For
service
only
OEM Password
For OEM only
Summary of Contents for HR91A
