Installation
8.
Driver Installation
Power down your PC.
Insert UFG-05 card in a vacant PCI slot in your PC.
Note:
The hardware installation must be done before the software installation.
Please use a PCI Rev 2.2 (66 MHz) slot for
UFG-05 32
or
UFG-05 Dual64
,
PCI-X (66 MHz) for
UFG-05 Dual64
, PCI Express 1.0 for
UFG-05 1E
and PCI
Express 2.0 for
UFG-05 4S
.
You can use either a 3.3 V or a 5 V slot
Boot the Windows XP system and log in
Note:
System administrator's privileges are required for performing the installation.
The Plug and Play subsystem will detect the newly installed UFG-05 family board.
In the
Welcome to the New Hardware Wizard
click
Cancel
. Please use the
install.exe
routine for pre-installation before the actual Windows installation.
Open the folder containing the requested driver type included in the UFG-05 family
Installation CD.
Run
install.exe
application.
Select
Allow
whenever the operating system prompts for permission.
Click
Install/Update
. Press
Continue
and
Apply
whenever the operating system
prompts for permission.
Click
Close
when the installation is completed. The UFG-05 driver is now ready for
use.