A-500 REAR PANEL
1. Channel 2 Input -
Connect the input source for channel two to either the balance
XLR or the balanced/unbalanced 1/4” input jacks. The 1/4” TRS
plug is configured as follows; Tip is positive, Ring is negative
and Sleeve is ground. The XLR jack is configured as follows; Pin
three positive, pin two negative, pin one ground. See page 9 for
more details on input configuration.
2. Channel 1 Input -
Connect the input source for channel one to either the balance
XLR or the balanced/unbalanced 1/4” input jacks. The 1/4” TRS
plug is configured as follows; Tip is positive, Ring is negative
and Sleeve is ground. The XLR jack is configured as follows; Pin
three negative, pin two postive, pin one ground. See
for
page 9
more details on input configuration.
3. Cooling Fan -
This is a dual speed cooling fan. This fan is used to cool the
internal parts of the amplifier when in use. Never block the fan
in any way or mount in an enclose rack, doing so may cause the
amplifier to overheat and fail.
4. Channel 2 Speaker Output - 5 Way Binding Post -
Connect your channel two speakers to channel two output.
5. Channel 1 Speaker Output - 5 Way Binding Post -
Connect your channel one speakers to channel one output.
6. Circuit Breaker -
This breaker is designed to protect the amplifier and your speak-
ers in the event of an AC overload. In the event of an electrical
overload the breaker will pop-out. To reset the breaker, push it in.
If the breaker continues to pop, stop using the amplifier and con-
tact your dealer.
7. Mono-Bridge/Stereo Selectable Switch -
This switch changes the amplifier operating mode from either
stereo or mono bridge. Amplifiers arrive to you preset in the ste-
reo operation mode.
8. A/C Power Input -
Plug this cable in to a standard 110- 220V wall outlet. Be sure
supplied voltage matches that of the required voltage of
that
you amplifier. Never plug your amplifier in to a wall outlet that
you not match the required voltage of your amplifier, serious
damage may occur to your unit.
Diagram 2
CAUTION
4 OHMS MINIMUM IMPEDANCE PRE CHANNEL
4 OHMS MINIMUM IMPEDANCE IN MONO BRIDGE MODE
INPUT
CH
1
WARNING:
W
PROFESSIONAL POWER AMPLIFIER
STEREO
BRIDGE
STEREO
BRIDGE
STEREO
BRIDGE
INPUT
CH
2
6
5
4
3
2
1
7
8
page 6
OUTPUT
BRIDGE
MONO
CH 2
CH 1
+
+
_
_
+
_
