Introduction Front Panel
Set Up Speakon Assembly Operating Modes Protection Features Specifications
Rear Panel
Figure
2
page 4
11. Fan Outlet Ports -
Cooling air enters the amplifier through the front
grills and exhausts through the fans. Be sure not to block these ports
when installing the amplifier or other associated equipment. Air must
flow unimpeded through these ports.
12. Remote RS-485 Link Output -
XLR output for connecting additional
DSP-4000 devices in a Daisy Chain mode.
13. Remote RS-485 Link Input -
XLR input for connecting the amplifier
from another DSP-4000 device in a network. RS485 Link Input can
also be used to connect a computer running the DSP-4000 software.
14. Channel 1-2 Balanced 1/4” TRS & XLR Input Connectors -
These
connectors accept input signals on balanced TRS and XLR input
plugs. Connectors for each channel are in parallel, the unused
connectors may be used for “loop through” connection to other
amplifiers.
TRS pin setting: Tip/signal positive, Ring/signal negative,
Sleeve/ground.
XLR pin setting: Pin-2/signal positive, Pin-3/signal negative, Pin-
1/ground.
15. Channel 1-2 XLR THRU Jack -
These jacks are used to send a
parallel signal from the channel 1 (or 2) input jack to another device or
amplifier.
1
6. Reset Button -
This button is used to reset the breaker.
17. Channel 1-2 Speakon Output -
Use pins 1+ and 1- of this 4-pole
Speakon connector to connect to your speaker's input jack.
18. Channel 1-2 Output Jack / 5-Way Binding Post -
Connect to your
speaker’s input jack. Red is positive signal and Black is negative
signal.
19. AC Power Input -
Plug this cable into a standard 110V or 220V wall
outlet. Be sure that the supplied voltage in your area matches the
amplifiers required voltage. Never plug your amplifier into a wall outlet
that does not match the required voltage of your amplifier, serious
damage may occur to your unit.
DSP-4000 REAR PANEL
UNiKA
DSP-4000
11
12
13
14
15
16
11
17
18
19
