background image

Page 1

Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's 
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons 

Intended to alert the user of the presence of important operating and maintenance (servicing) 
instructions in the literature accompanying the product. 

CAUTION:

 Risk of electrical shock -

DO NOT OPEN

 

CAUTION:

 To reduce the risk of electric shock, do not remove cover. No user serviceable parts inside 

                     Refer servicing to qualified service personnel.
 
WARNING:

 To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. 

                     Before using this appliance, read the operating guide for further warnings. 

WARNING! 

For optimun performance and reliability DO NOT 
PRESENT THE AMPLIFIER WITH A SPEAKER 
LOAD OF LESS THAN 2 OHMS. OR A 
COMBINATION OF SPEAKERS THAT 
TOGETHER ARE LESS THAN 2 OHMS!
 
Using one speaker, it must be rated at 2 ohms 
minimum. 
Using two speakers, they must be rated each at 4 
ohms minimum. 
Using three speakers, they must be rated each at 8 
ohms minimum. 

AVIS ! 

Pour assurer la Fiabilte et obtenit une performance 
optimale, ne soumette jamais 1'amplificateur a une 
charge d'impedance totale inferieure a 2 ohms, ni 
avec un H.P. ni en combinaison des H.P.
 
AVEC un H.P., il Faut une charge d'impedance 
minimum de 2 ohms. 
AVEC deux H.P., il Faut pour chaoun une charge 
d'impedance minimum de 4 ohms. 
AVEC trois H.P., il Faut pour chaoun une churge 
d'impedance minimum de 8 ohms. 

FRONT  PANEL...................................2
REAR  PANEL.....................................2
INPUTS..............................................3
THRU.................................................3
OUTPUT.............................................3
CLIP LIMITER.....................................3

INPUT FILTER....................................4
PARALLEL  INPUT  MODE...................4
BRIDGE  MONO  MODE......................5
STEREO  MODE.................................6
PROTECTION...................................6
SPECIFICATONS...............................7

PROFESSIONAL POWER AMPLIFIERS

UNiK A

NP-SERIES

Summary of Contents for NP Series









Reviews: