background image

page 2

IMPORTANT PRECAUTIONS

To reduce the risk of electrical shock or fire, do not expose this unit rain or 
moisture.

Do not spill water or other liquids  into or on to your unit.

Do not attempt to operate this unit if the power cord has been frayed or 
broken.

Do not attempt to remove or break off the ground prong from the electrical 
cord. This prong is used to reduce the risk of electrical shock and f re in 
case of an internal short.

Disconnect main power before making any type of connection.

Do not remove the cover under any conditions. There are no user 
serviceable parts inside.

Never plug this unit in to a dimmer pack.

Always be sure to mount this unit in an area that will allow proper 
ventilation. Allow about 6” (15cm) between this device and a wall.

Do not attempt to operate this unit, if it becomes damaged.

This unit is intended for indoor use only, use of this product outdoors voids 
all warranties.

During long periods of non-use, disconnect the unit’s main power.

Always mount this unit in a safe and stable manner.

Power cords should be routed so they are not likely to be walked on, 
pinched by items placed upon or against them.

Cleaning -The outside of the unit should be wipe down with a soft cloth and 
mild cleaner when needed.

Heat -The amplifier should be situated away from heat sources such as 
radiators, heat registers, stoves, or other appliances (including amplifiers) 
that produce heat.

The fixture should  be serviced by qualified service personnel when:

A. The power-supply cord or the plug has been damaged.

B. Objects have fallen, or liquid has been spilled into the unit.

C. The appliance has been exposed to rain or water.

D. The fixture does not appear to operate normally or exhibits a 

marked change in performance.

Congratulations and thank you for purchasing V-8000/V-9000

 

amplifier. 

These amplifiers are representation of UNiKA’s continuing commitment to 

produce the best and highest quality audio products at an affordable price. 

These amplifiers are designed to provide a big impact in sound 

reproduction. Please read and understand this manual completely before 

attempting to operate your new amplifier. This booklet contains important 

information concerning the proper and safe operation of your new amplifier.

UNPACKING:

 Every V-8000/V-9000 amplifier has been thoroughly 

tested and has been shipped in perfect operating condition. Carefully check 

the shipping carton for damage that may have occurred during shipping. If 

the carton appears to be damaged, carefully inspect your unit for any 

damage and be sure all accessories necessary to operate the system have 

arrived intact. In the event damage has been found or parts are missing, 

please contact your dealer for further instructions.

INSTALLATION:

 These amplifiers are designed to mount into a 

standard 19”rack. The front panel provides four holes used to screw the unit 

into a rack. The unit also provides a way to rear mount the unit into a rack for 

added security. Rear mounting the unit is especially recommended if the 

unit is to mounted into a mobile rack. 

INTRODUCTION

Introduction

      Front Panel      Rear Panel      Set Up      Speakon Assembly      Operating Modes      Protection      Features      Specifications

UNiKA

 V-8000/V-9000

Summary of Contents for V-8000

















Reviews: