06
07 Solder on the resistors on all the
switches (skip this step if you do not
need LEDs)
10 Reorient your PCB as follows
12 (Optional) Place sellotape onto the
location marked with a red rectangle
13 Orient the RIGHT controller as follows
(Controller package should be marked
LEFT or RIGHT)
14 Place and solder the controller
as follows
09 If you wish to install LEDs,solder on
the resistors pictured below, notice
that the diodes are facing upwards.
11 Solder on the TRRS jack and MOSFET,
make sure the TRRS jack is facing up
and the diodes are facing down
09 Insert 2 leads cut from the diodes and
solder them by following the white
lines on the PCB
100ohm
100kohm
