G85793/H10579 Spacesaver Power Signal Generator
NFU 600
Purpose:
The Spacesaver Power Signal Generator is ideal for all experiments in
sound, driving loudspeakers and also the Vibration Generator with
accessories for the study of resonance and standing waves.
Output:
Sine, square, triangular and TTL waveforms.
Frequency range 0.1Hz to 110kHz in 6 decades.
Accuracy 5% above 10Hz
Power output up to 2.5W, i.e. 5V rms (7V peak) into a 10 ohm load
Frequency response d.c. to 110kHz,
Output impedance 1 ohm (high current loads) or 100 ohm.
Ratings:
230V ac +/-10% 50Hz 100VA Class I
Fuse: T250mA time delay
Internal fuse: T2A time delay
Temperature range: 10 to 40°C
Humidity: 10 to 90% RH
Mass: 4.3kg
EMC:
This equipment is Class A according to the EMC standard EN55011 and is
intended for use in a non-domestic environment only. Interference from
nearby sources of RFI (radio frequency interference) may affect the output signals. Likewise, this
equipment may affect other equipment: PCs, laptops, tablets and mobile phones may be affected.
Warnings:
For your safety, this product should be used in accordance with these instructions, otherwise the protection
provided may be impaired.
Do not open or remove covers or panels. Repairs and service may only be carried out by our repair agent,
otherwise the warranty may be void.
Use only the 3-core mains cable supplied with the unit. If the mains cable is replaced, the rating of the
replacement must be the same or better than the original.
The unit must be earthed at all times. The unit is earthed/grounded through the 3-core mains lead, so no
additional earth connection is required.
Always position the generator so that it can be disconnected from the mains, if an emergency arises.
This unit is intended for use in DRY conditions. Avoid spillage of water and other liquids on to the unit. If
spillage occurs, disconnect the mains supply.
version G85793 2017
