EN
- 5 -
Assembly and Commissioning
1. Preparation before assembly
1.1 Please identify the authenticity of the product according to the following methods
The products produced by the Company are provided with special anti-counterfeiting codes (consisting of 20 Arabic numerals)
in the outer case, body, warranty card and other three locations. Please check the anti-counterfeiting codes in three locations
carefully. It is regarded as authentic if the other 19 digits are consistent except for the first digit.
1.2 Please refer to the packing list of the Manual to confirm that the installation components are complete.
2. Assembly process
CF filter
Step 1:
Open the package and take out the
components; insert the water receiver into
the correct position of the purifier.
Step 2:
Open the water container cap and lift the
water container up.
Step 3:
Insert CF filter inward as shown in the figure
(the protrusion at the bottom of the filter is
on the left, aligned with the purifier slot) and
keep the pull ring of the filter outside.
Reverse
osmosis
membrane
filter
Alignment
point
Composite
filter
Step 4:
Hold the upper part of the filter, rotate it to the right after alignment and install the new
filter to ensure that the filter is fully assembled according to the instructions above the filter
label of the melt-blown polypropylene carbon fiber composite filter(PPCF) and reverse
osmosis membrane filter (RO). Align the water container back to the bottom slot for purifier
commissioning after the installation of filter.
3. Debugging method
3.1 Add water at the large volume side of the water container ((no water is added to the small volume side) to the "MAX" level
prompt line. Close the rear cap of the purifier, connect the power supply (in the case of no leakage in the purifier) and flush the
PPCF filter, RO filter and CF filter . It is recommended to flush for more than 10 minutes until the outlet water is clear without
black water or peculiar smell. The purifier will automatically flush for 2 minutes when the power is reconnected for each time (the
blue aperture and water shortage icon on the screen flashes during flushing). During the flushing, please lift the water container
timely to pour out the rejected water after the small volume side is full and add water at the large volume side.
3.2 It is necessary to flush the RO filter in order to maximize the purification effect of the RO filter. Please follow the following
steps:
Switch on and purify water 24L under normal condition (drain water through boiling water function). The purifier will
purify water automatically after 2 minutes of automatic flushing. The indicator light of "water purification" flashes during water
purification; the indicator light of "water purification" is off after the water purification is completed. Please drain the water
with boiling water function after each water purification is completed. During water purification, please lift the water container
timely to pour out the rejected water after the water at the large volume side is full and add water at the large volume side of
the water container.
Stop water purification and leave the purifier standing for 24 h.
The produced water can be directly drunk after normal water purification for 24 L.
