background image

ANSI FL1 Standard

5

Lumens

10 M

260 H

750

Lumens

100 M4

 H

HIGH

LOW

*these runtimes are based on using 2 x 2000mAh li-ion 18650 batteries. Using 1 battery will

reduce runtimes. Using higher/lower mAh batteries will increase/reduce runtimes.

www.unilite.co.uk

FEATURES

•  Super bright 750 Lumen white CREE LED

•  Easy twist smooth dimming switch

•  Wider angle light spread

•  Anti-dazzle retractable light shield

•  Rear red light for extra visibility 

•  45° rotational head

•  IPX6 water resistant

•  Fully adjustable non-slip silicone headbands

•  Hard-shell protective zipped storage case included 

•  2 x High power 2000mAh Li-ion 18650 batteries included

•  Parallel circuitry (runs with1 or 2 batteries)

•  Now faster USB Type-C charging - 3 ½ hours

BATTERY - 2 x 3.7v 2000 mAh li-ion rechargeable batteries (inc)

DIMENSIONS - Headtorch: 38 x 60 x 45 mm

 

            Battery Pack: 65 x 90 x 45 mm

WEIGHT - 275g (with 2 batteries)

ADVICE & IMPORTANT INFORMATION!

Do not look directly at the LED. Do not operate in direct sunlight or extreme temperature conditions 

(below -30⁰C or above 60⁰C). 

The LED will become hot when switched on; do not touch and do not place face down on any surface 

– risk of fire!

Do not use the device if there is any visible damage to the housing, wire,  switch, charge port or cables. 

Take care when using a USB plug adaptor, check for any damage. Do not exceed 5V 2.1A charging input 

or damage may occur to the batteries. 

The rechargeable batteries will reach full performance after a few complete charging and discharging 

cycles. 

To keep the rechargeable batteries in optimum condition, they should be recharged every 3-6 months, 

especially if not being used for a long period of time. Always fully charge batteries before storage and 

remember to remove batteries from head torch before storage to avoid battery depletion. 

ONLY USE HIGH-QUALITY 18650 LI-ION BATTERIES WITH OVER CHARGE PROTECTION OTHERWISE 

DAMAGE MAY OCCUR TO THE HEAD TORCH.

Always protect lithium batteries from heat, intense sunlight, fire, water and moisture – danger of 

explosion! 

If a battery is damaged, fluids can leak out. AVOID contact as this can lead to skin irritation and/or 

burns. If skin contact occurs, rinse thoroughly with water. If irritation persists, seek medical advice. 

Seek immediate medical assistance if battery fluid comes into contact with the eyes.

Children under 12 years of age should only use the product under adult supervision.

Do not open, disassemble or attempt to modify the product; this will void the warranty and can be 

dangerous. Improper use or modification is not covered under the warranty.

Take care not to let the lens come into contact with hard/sharp objects, damage to the lens will affect 

light output. 

This product is water resistant to IPX6 – DO NOT SUBMERGE.

If the product has been affected by damp, remove the batteries and leave the unit open and allow 

to dry out completely before using. If the batteries are installed and the headlight does not work, 

try checking for the following: (1) Operate the switch several times. (2) Check that the batteries are 

inserted the correct way around according to polarity markings. (3) Check there is no debris on the 

contacts that might affect the battery connection. (4) Check there is no water or dampness in the light, 

if so, allow it to fully dry out and try again. 

If the product has been subjected to excessive moisture/water the warranty may be void. 

This product has a 1 year standard warranty (or extended to 2 years once registered online at WWW.

UNILITE.CO.UK/WARRANTY) against manufacturing faults and defects. It does not cover normal wear 

and tear, modifications, accidental damage or poor maintenance. Unilite warranties do not cover 

battery leaks or the use of incorrect chargers and cables that can damage batteries.

Do not dispose of this device in normal household waste. It must be disposed of via an authorised 

disposal centre or at your local waste disposal unit. 

Please reuse or recycle packaging where possible. Keep these instructions for future reference or for 

subsequent possessors.

PS-HDL9R

OPERATION

REAR RED LIGHT

WIDER LIGHTING ANGLE

ANTI-DAZZLE SCREEN

CHARGING

1.  Only use a 5V USB-C cable (max 2.1A)

2.  Lift the charging port cover on the bottom of the battery pack. 

3.  Plug the USB-C end of the cable into the charge port.

4.  Plug the USB-A end of the cable into any USB charging port (do not 

exceed 5V 2.1A charging input or damage may occur).

5.  5 x Blue LEDs will flash to indicate charging status. All 5 LEDs will 

light up constantly to confirm the batteries are fully charged. 

6.  Charge Time: 3½ hrs

**Warranty void if not used with the specified cable & max input**

Twist switch to turn on 

the headlight

750

Lumens

Smooth Twist

Dimming Operation

low-to-high

5

Lumens

Power & Recharging 

Indicators 

USB Type-C

95%-100% 

65%-95% 

35%-65% 

15%-35%

<15% 

Recharging indicator

95%-100% 
65%-95% 
35%-65% 
15%-35%
<15% 

Power indicator

Anti-dazzle screen

Press switch to 

turn red led light on

Reviews: