100psi Pneumatic 2 in 1 Nailer
E&OE
© 2017 Unimac
5
Do not connect this tool to a system with maximum potential.
Only connect tool to air supply with a coupling that will release all pressure from the tool when disconnected.
Disconnect tool from air supply before performing maintenance, clearing a jammed fastener, leaving the work
area, handing the tool to another person, or making adjustments.
Preparing the Tool
1. After reading and understanding this entire manual, connect tool to air supply. (See Figure 12).
WARNING
: Keep tool pointed away from yourself and others at all times.
Always connect tool to air supply before loading fasteners.
Always wear Z87 approved safety glasses and hearing protection when preparing or operating the tool.
Never use a tool that leaks air or needs repair.
