Pneumatic Floor Nailer / Stapler
E&OE
© 2017 Unimac
7
may cycle when tool is connected to the air supply.
•
Use the tool with the correct types and sizes of fastener. Do NOT load different size/types of fasteners at
the same time.
•
Do NOT attempt to drive fasteners into material that they are not designed to penetrate, such as metal,
concrete, tiles etc.
•
Do NOT drive fasteners on top of other fasteners.
•
Strike the activator / plunger using rubber mallets only.
•
Do NOT use the tool as a hammer for aligning floor boards etc.
Transportation Safety
•
Always remove all fasteners from the tool before transporting or working on it (adjusting etc).
•
Always disconnect the tool from the air supply before transporting or working on it.
