※ CAUTION: Repositioning of the Velcro stickers of the speakers and microphones more than
one time may result in poor adhesion. ( Velcro stickers are available on the website,
http://www.chatterboxglobal.com/
)
Open-Face microphone
Ultra Slim Full-face microphone
Speakers
Cradle and Bracket
Installation of cradle, bracket and BiT-4 main device
1.
Prepare the provided cradle, bracket, screws and L-wrench.
2.
Attach the metal bracket with rubber to face cradle to the cradle using screws but do not fully
tighten at this stage.
3.
Slide the bracket iron plate into the gap between the helmet shell and the inner pad of the left
side.
4.
Now tighten the screws on the bracket to fit the cradle to the helmet firmly using the L wrench.
5.
Connect the microphone and speakers to the cradle. Make sure to match the arrow at the end
of the plug and jack.
6.
Insert the guide fin on the back of the product along the slide of the cradle and push it down
until you hear the 'click' sound.
※
CAUTION: If screws of the cradle are over-tightened, back of cradle may be bended and this may
result in difficulty setting the BiT-4 main device on the cradle or main product may fall off by shock
or vibration.
