31
UDR-204(C) Operation manual Revision 3.0
3.1.4.4 RS-485
Setting
Choose from the following to set PTZ RS-485 baud rate: 2400, 4800, 9600, 19200, 38400,
57600, 115200 bps.
3.1.4.5 TEST
Users can test the PTZ control after setting the parameters. After clicking the TEST button,
PTZ control will be available and tested by up/down key. Pan/tilt and Zoom/Focus mode will
be controlled after entering OK key button.
PTZ control speed will be controlled by PLAY button for higher speed or by R-PLAY button
for precision control
Users can access prior menu with PTZ key entering after finishing test.
3.1.4.6 Additional PTZ Menus
Users can access additional PTZ menu after pressing Menu button in the PTZ mode.
Figure 3-5 Additional PTZ Menu
-
Set Preset: To preset the position of the Pan/Tilt drive. Users can preset 4 positions
selected by Left/Right buttons and save the preset by pressing OK button.
