8. Use a 2.4 mm screwdriver to turn the pin to the “release”
setting (gently turn counter-clockwise until it stops).
9. Use a 2-angle hook to access and pull the pin from the hole.
10. Remove the plastic pin on the opposite end by drilling a
hole in the center.
11. Turn the pin counter-clockwise to the “release” setting as
usual.
OKIDATA B6300
•
TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.
uninet
imaging.com
