31. Clean the contacts on the right side end cap and replace the conductive grease.
Snap the end cap into place and replace the three screws.
32. To replace the chip, drill out the two plastic rivets with a
small drill. Remove the cover and chip.
XEROX WORKCENTRE 3210
•
3220 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2011 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.
uninet
imaging.com
