19. On the supply hopper, carefully pry out the fill plug and
dump out any remaining toner. The fill plug can be difficult to
remove as it is recessed. Take a small common screwdriver
and work it around the edge lifting slightly until it comes loose.
20. Remove the developer roller.
21. Remove the two screws from the doctor blade, remove the
blade. Clean out all the remaining toner from the hopper.
22. Make sure the doctor blade sealing foam and the
developer roller seals are clean and intact.
XEROX WORKCENTRE 3210
•
3220 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2011 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.
uninet
imaging.com
