[Water Tank and Drain-Pipe]
• The condensate water on the surface
of evaporator will be stored in the tank
whose volume is 25L. When the water is
full, water level switch acts. Automatically
stops working. Remove the tank, pour out
the water, and place it to the original
position, then turn on the machine again.
Note-
When take out the tank, prevent damage
of float the circular and waterspout
collision.
• The condensate water can be discharged
directly by drain-pipe. Remove the tank,
unload the block on the water outlet,
connect the drain-pipe with the water
spout. The drain-pipe can also be pulled
through the hole under the machine.
[ Maintenance and Inspection]
A
CAUTION
♦
Clean the filter screens regularly, the dirt may influence inlet
air volume, and cause the heat exchanger to frost, machine
breakdown.
eTo wash the filter screens, open the front panel to get the front filter
screen.
Get back filter screen directly. Use a dust collector to clean then
wash them.
Use them after they are totally dry.
Note:
Do not use thinner, volatile oil or medicine to clean the surface of
the machine.
eMake sure the screws are fastened.
elf the machine is not used for a long time, pour out the water in
the tank and dry it .
eDo not tap or turn over the machine.
eProtect from light and moisture. Keep the machine out of the
reach of children.
Note:
During maintenance and inspection periods, make sure power is
off when changing parts.
Power off to store the machine.
6
Circular Float
Water
Spout
c::
Muff Couplin
Take om�/
tlJ
�
}
/
Back filter
\
\1/
screen
