4
1.
Programmable outlets: connect to non-critical loads.
2.
Output receptacles: connect to mission-critical loads.
3.
AC input
4.
Input circuit breaker
5.
Network/Fax/Modem surge protection
6.
Emergency power off function connector (EPO)
7.
USB communication port
8.
RS-232 communication port
9.
SNMP intelligent slot
10.
External battery connector (only available for long-run models)
11.
Input terminal
12.
Output circuit breaker
2-2. Install the UPS
For safety consideration, the UPS is shipped out from factory without connecting battery wires.
Before install the UPS, please follow below steps to re-connect battery wires first.
Step 1
Step 2
Step 3
Remove front panel.
Connect the AC input and
re-connect battery wires.
Put the front panel back to the
unit.
This UPS can be either displayed on the desk or mounted in the 19” rack chassis. Please choose
proper installation to position this UPS.
Rack-mount Installation
Step 1
Step 2