:
ii
UPS471-02-00 PW9000DPA User Manual UK Dated 06/08/14
Operation
43
4.1 Introduction
43
4.1.1 Operating procedure summary
43
4.2 Operating Instructions
43
4.2.1 Starting the UPS system from the maintenance bypass
44
4.2.2 Individual module start/stop procedure in a parallel system
45
4.2.3 Transfer the load from UPS to maintenance bypass mode
47
4.2.4 Complete system shutdown
49
4.3 Replacement of the UPS module in a single module system
50
4.3.1 Removing a UPS Module in a single module system (e.g. DPA-50)
50
4.3.2 Refitting the UPS module
51
4.4 Replacing a module in a REDUNDANT multi-module system
51
4.4.1 Removing the UPS module
51
4.4.2 Inserting a UPS module
52
4.5 Replacing a module in a CAPACITY multi-module system
52
4.5.1 Removing a module
53
4.5.2 Refitting a module in a capacity multi-module system
54
Maintenance
55
5.1 Introduction
55
5.2 System calibration
55
5.3 User responsibilities
55
5.4 Routine maintenance
55
5.5 Battery testing
56
5.6 Battery maintenance
56
5.7 Battery disposal and recycling
56
Troubleshooting
57
6.1 Alarms
57
6.2 Menu, Commands, Event Log, Measurements,
57
6.3 Fault Identification and Rectification Messages and Alarms
58
6.4 Contacting Service
58
Options
59
7.1 Introduction
59
7.2 Dry port (volt-free contacts)
60
7.2.1 Input interfaces terminal block X1
60
7.2.2 Output interfaces terminal blocks X2, X3, X4
61
7.3 RS232 Computer serial interface – USB & JD11
62
7.4 RS232 Interface for multidrop – JD12
62
7.5 SNMP/ Modem slots for remote monitoring/control
63
7.6 UPS Monitoring and automated control software
63
7.6.1 The importance of UPS management
63
7.6.2 WAVEMON Shutdown and Management Software
64
7.6.3 PowerREPORTER™ management software
65
