Obit.6 has a total of six Input Channels, each with valve preamp stages and dual stereo
inputs. Channels 1
-
4 feature both Line and Phono (RIAA) Inputs, Channel 5 has dual Line
Inputs (Line A and Line B), and Channel 6 accommodates Line A/Mic and Line B inputs. The
Mic Input Select switch is located on the rear panel and overrides the Line A input source.
Aux –
The Auxiliary Send controls the channel signal level sent to the Aux Output, primarily
for use with external effects or audio processors.
Pre –
The Pre/Post button selects whether the Aux Send signal level is affected by the
Channel Fader. When Pre is selected, the Aux Send level is not affected by the Channel Fader.
Trim –
Controls the level of the input signal from fully OFF to a maximum gain of +10dBu.
Use in conjunction with the Channel VU Meter to set the optimum signal level, with the
average lighting the green 0VU LED and the peaks just lighting the 3VU LED.
RIAA/Line select –
(CH1
-
4) Switches between PHONO (RIAA) Input in the up position
and LINE in the down position. The PHONO input has RIAA equalisation for use with all good
quality moving magnet turntable cartridges
HPF –
The channel High Pass Filter adjusts the low frequency cut
-
off of the channel signal,
and features a two
-
pole response with a swept frequency range from 10Hz to 1.1kHz
.
Input Channel Controls
Summary of Contents for Orbit.6
