Install remote receiver into the socket connector on the bottom of controller.
Caution!
Remote receiver is electrostatic sensitive device. Avoid touching
the contacts of Receiver before it is installed into the socket. Install receiver precisely to predefined location, marked with white rectangle on the controller.
Plug-in the antenna connector into the controller.
Attach the antenna into the antenna holder.
Receiving signal from remote controller depends of antenna position so
the self-adhesive holder must be attached as presentend on image.
Install the controller back into the enclosure and fix it with four screws.
Testing the Remote Controller system
- Plug-in the power cord and turn-on the key
- Press and hold the
button
Up
on remote controller for about 2 seconds. The stand should start to move upwards
and should stop after releasing the
button Up
.
- Short press and release of
button Up
. The stand should start to move upwards until the press of button
Stop
on
remote controller before it reaches upper limit position.
- Repeat the same procedure for
button Down
and
Stop
on remote controller.
Close the enclosure rear cover and
attach it with screws.
