| 27
C64.65201 Issue 3
Jun 2019
The spherical washer sets are essential for the tilt adjustment and shall not be
omitted
When the signal is aligned correctly to the point on the signal sighting form, ensure
all the mounting nuts are correctly torque loaded in accordance with the ALT Manual
and the alignment scope is removed and stored in its protective case.
If required the adaptor plate and camera described in the Detachable Signal
Alignment Scope section above can be fitted.
INSTRUCTIONS COMMON TO BOTH VARIANTS
Electrical Connection
To reduce the amount of spares that need to be held, all CLS LITE Modules have the
splitter cable for the second Yellow module attached. If the signal only uses a single
Red Yellow Green module the splitter cable will have a blanking cap fitted and it will
be secured to the main plug coupler using a cable tie or fitted in the bracket on the
inside of the door.
