−
pos. 6 (Fault condition in fire detecting line of a remote fire control panel)
in continuous yellow light;
−
pos.7 (Fault condition in monitored output of a remote fire control panel) in
continuous yellow light;
−
The individual indicator for Fault condition of the remote fire control panel
illuminates in yellow light.
If the sounder is suppressed by button
(Alarm), the LED indicator of the button
illuminates in continuous red light.
5.2.2.
Text messages
Upon fault conditions when the repeater is not in Fire condition screens with the
specific fault condition are displayed.
When the fire control panel is in Fire condition the messages for Fault conditions are
suppressed.
The suppressed messages are displayed in Information and Control Mode.
5.3. Using the keypad
For fault condition 2 active buttons are supported.
Активни
бутона
. Where the fire
control panel operates in combination of other conditions, their buttons are active too.
5.3.1
. Button
(Alarm)
Press it to:
−
switch the local sounder off if it was activated for Fire condition or Fault condition;
−
activate the local sounder if the fire control panel is in Fire condition or Fault
condition and the local sounder has been switched off by preceding pressing of
the same button.
The LED indicator of the button illuminates if the local sounder is switched off for
Fire Condition or Fault Condition.
Button’s operation does not effect and is not cancelled by the following events:
- a new fault condition will trigger the local sounder for Fault condition only.
5.3.2
. Button
(Menu)
Press the button to enter Information and Control Mode.
6. Disabled component mode
From the menu press button
and button
to enter menu
Disables
. It is
possible to disable the outputs for Fire condition in the Repeater:
> Out1 ;
> Out2 ;
> RelFire ;
If an output is disabled it is not activated for Fire condition or for Fault condition in
the line of the monitored outputs.
UniPOS wishes you a successful work!
5
