Page 13
P O W E R I N G T E C H N O L O G Y
Manual No. PM110-6500-00 rev-2a
PM110-6500-00-rev2a-0117.indd
Chapter 3 System Safety
3.1 Safety Warnings and Guidelines
The following warnings and guidelines should be followed by properly trained and authorized
personnel when installing, operating, commissioning or maintaining this equipment.
Neglecting the instructions may be dangerous to personnel and equipment.
3.1.1 System Markings
The following markings are found on the Power System:
Product Label
- The product label contains the system part number, model number, system
ratings and safety approvals. The label is located on the left side of top cover.
3.1.2 Safety Recommendations
Any device that uses electricity requires proper guidelines to ensure safety.
•
The Power System should only be installed or serviced by qualified personnel.
• Always keep tools away from walkways and aisles. Tools present a tripping hazard
in confined areas.
• Keep the system area clear and dust-free during and after the installation.
•
Always know the location of emergency shut-off switches in case of an accident.
• Always wear appropriate eye protection and use appropriate tools for working with
high voltage equipment and batteries.
• Do not perform any action that creates a potential hazard to other people in the system
area.
• Never work alone in potentially hazardous conditions.
• Always check for possible hazards before beginning work.
• Remove watches, rings and jewelry that may present a hazard while working on the
power system.
3.1.3 Installation Warning
The following safety guidelines should be observed when transporting or moving the system:
•
Before moving the Power System, read the system specifications sheet to determine
whether the install site meets all the size, environmental, and power requirements.
• The system and the equipment included, should only be moved and installed by
qualified personnel to prevent bodily injury or any other hazardous conditions.
