se on the bottom plate. Measure and drill the
hole from the backside. The most important issue is to
ost
forward.
d
Lead the cable up on the back side
Main Box. It is important that the c
recommend that you use strips to fi
onnector marked RECV 1 on the
ceiver.
the
he
Remember to place the infrared transmitter at the same
Magnet receiver
Mounting the magnet receiver.
The best place to mount the magnet receiver is
lengthwi
minimize the vibrations to the receiver. The m
common placement of the magnet receiver is at the
very front of the bottom plate, with the cable facing
The distance between the receiver and asphalt must
not exceed 50 mm.
Make sure that the cable is fixe properly.
of the front cover and into the
able is fixed properly. We
x the cable to the front cover.
The cable is mounted in the c
Main Box. Tighten the connector hard with your fingers.
Infrared receiver
Mounting the Infrared re
The best place to mount the infrared receiver is behind
front cover. Measure and drill the hole from the side. T
most important issue is to mount the receiver horizontal.
height as the infrared receiver at least 3 meters from the
track.
UNIPRO – The original Laptimer
9
