13
RPM wire attached with cable ties.
The RPM wire needs to run all the way from
the Laptimer to the engine on the back.
Secure the wire all the way with cable ties.
The RPM wire is running alone all the way
to the ignition.
RPM wire mounted to pick up the ignition
signal from the ignition wire.
The RPM wire is attached to the ignition cable
in a way that gives a good pick up of the sig-
nal. Twist the wire around the cable and make
a loop at the end like shown on the picture.
RUNNING CABLES
The installation of the Laptimer should be seen
as a permanent installation on the go-kart and
the time to run the cable in a nice way is time
well spend.
Cable fixed to frame. Run RPM wire sepa-
rately.
Use plenty of cable ties and make sure to use
nice soft bends on the cable. When tightening
the cable ties, make sure not to tightening
them too hard to avoid squeeze the cable.
Cable fixed to the frame with cable ties.
Running the cables from the Laptimer on the
steering wheel is the biggest challenge. The
cable need to be mounted in a way that the
steering wheel can be moved freely.
I n s t a l l i n g t h e
L a p t i m e r
Installation
Summary of Contents for UniGo 5005
