13
3
SETTING PROCEDURE
13
SET
TING PROCEDURE
Chapter
3
3-2.
Setting Procedure
■
Setting Method
About set value LOCK (Setting code 49) and calibration value LOCK
(Setting code 48)
Set values marked with “
○
” under Set value LOCK and Calibration value LOCK in "9-1.Setting
Code List" on page 78 cannot be changed unless these LOCKs are released. Therefore, change
setting(s) after checking that they are released. (Refer to "
Calibration Value Lock Release
(Setting code 48)" on page 20 and "
Set Value Lock Release (Setting code 49)" on page 20.)
Setting mode
is displayed.
Select a setting item.
The most significant digit starts blinking to prompt setting.
Select a digit where setting is desired.
Set Value is validated.
“F0” of setting Mode 0
Setting item
Set value input
“F1” of setting Mode 1
is displayed.
is displayed.
“F2” of setting Mode 2
is displayed.
“F9” of setting Mode 9
[FNC]
△
[ ]
[
△
] [
▽
]
△
[ ]
[ ]
[ ]
△
[ ]
△
[ ]
△
[ ]
Display the next setting mode.
△
[ ]
Go back to setting item selection.
[FNC]
The item number and
Display the current setting mode and
[FNC]
go back to setting mode selection.
Set a value.
[
△
] [
▽
]
selection
selection
set value are displayed.
If one minute has elapsed after [FNC] key is pressed without any key hit before
[
] key is pressed,the setting is canceled and the indicated value is displayed
again. The set value is not stored in this case.
Point
