15.Waveform Reading
93
The measured value of the cursor-placed waveform is displayed as the present value.
At this time, the High and Low Limits (X/Y-axis) are also displayed. Details of the
numerical display are as follows. (The X-axis reading display is the same as in "14-4.
・
Even if the cursor seems to be placed at the "+" mark, a different point
may actually be read depending on the display scaling. For confirming
accurate values, press the "Hold Jump" key. (See "15-1-4. Hold Jump
Function" P95.)
・
In the Pulse Hold / Hysteresis 2 mode, Y-axis High and Low Limits are
displayed only when the cursor is placed at the "+" mark. In other cases,
"----" is displayed.
・
In the Waveform Comparison / Waveform and Displacement
Comparison mode, Y-axis High and Low Limits are displayed as "----"
where High and Low Limit Waveforms are not available.
・
In the High-Low Relative mode, if Y-axis High and Low Limits exceed
±
10000, "--HI--" and "--LO--" are displayed, respectively.
・
In the Hysteresis / Hysteresis 2 / Waveform and Displacement
Comparison mode, the display of the X-axis High / Low Limit reading
section changes according to the Displacement High-Low Mode setting
(See "16-2-8. Displacement High-low Mode / Displacement High Limit /
Displacement Low Limit / Displacement Hold High Limit / Displacement
Hold Low Limit" P110.) as follows
Hold Value: Displacement Hold High / Low Limit
Peak Value: Displacement High / Low Limit
Both:
"+" Mark Section: Displacement Hold High / Low Limit
Others:
Displacement High / Low Limit
・
Be aware that the sampled waveform display is not updated when
the Waveform Reading screen is displayed.
・
Display of X-axis High and Low Limits is not available in the Multi-
Hold / Waveform Comparison mode.
10.00
cm
10.00
cm
10.00
cm
Y-axis readings
X-axis readings
100.0kN
High limit
Low limit
100.0kN
100.0kN
Present value
