7.Measurement Operation Functional Settings
41
7-3. Sampling Reset
If CH1/CH2 input calibration, Operation Mode, or PUI setting (optionally mounted) is
changed, the F395 stops sampling, and moves to a sampling waiting condition.
At this time, the results of hold / comparison are also reset.
7-4. X/Y-axis Setting by Operation Mode and Input CH
Analog input CH1/CH2 functions as X/Y-axis analog input depending on the Operation
Mode.
* Set CH1/CH2 under Select Analog CH. (See "16-2-3. Select Analog CH" P104.)
The current X/Y-axis setting of CH2 can be confirmed by the Axis setting on the CH2
Input Calibration screen. (The setting cannot be changed by this item.)
About advance waveform display
When the operation mode is Multi-Hold or Waveform Comparison, a
waveform is displayed gradually without waiting for completion of taking-
in of the waveform by setting the sampling rate to 100Hz or 200Hz.
The display rate changes according to the X-axis scaling.
This function simply handles waveform data, and hold points are
displayed after measurement.
The previous waveform is dismissed when the next measurement starts.
(The waveform can be read.)
Advance display is not carried out unless the main screen is displayed
when a measurement starts.
Operation Mode
Y-axis
X-axis
Multi-Hold
CH1/CH2
Time
Wave Comp
CH1/CH2
Time
Hysteresis
CH1
CH2
(displacement input)
Wave&Displace
CH1
CH2
(displacement input)
Hysteresis2
CH1
CH2
(displacement input)
