5
2. Camera Setup
A basic camera and frame grabber system setup, as shown in Figure 1 below, requires a UP-
1830CL-12B camera, a standard C-mount lens, a PS-12C power supply or equivalent, a PC system
with a monitor, a frame grabber, and an external trigger device if necessary.
Figure 1. Camera and Frame Grabber System Setup
3. Camera Functions
3.1 12-Pin Connector
The 12-pin Hirose connector is located on the
rear panel of the camera. All ground signals
on pin 1, 3, 5, and 8 are common grounds.
+12 V DC input is recommended on pin 2, but
this camera should wit12 V
±
1V
input voltage. Make sure to set the NM/AM
switch to NM position for external HD and VD
locking. Figure 2 below shows a top view of
the 12-pin Hirose connector.
Pin No.
UP-1830CL-12B
1
GND
2
+12V DC input
3
GND
4
Video
5
GND
6
N/C
7
N/C
8
GND
9
N/C
10
N/C
11
Integration control
12
N/C
Figure 2. 12-Pin Hirose Connector
