Unique Retro UGP-175L R AC, Owner'S Manual

5

INSTALLATION INSTRUCTIONS

IMPORTANT:

 After transit where the freezer has been on its side or back, ensure that the freezer is 

in a level, upright position for 12 hours before connecting the appliance to a power source, this will 

reduce the possibility of a malfunction in the cooling system from handling during transportation..

UNPACKING AND CLEANING

Remove all packaging and securing tapes from the appliance. To avoid injury and causing dam-

age to the appliance, be extremely cautious when using sharp or pointed tools to complete this 

task. Keep children away from the packaging material 

- DANGER OF SUFFOCATION! 

 Wash the 

inside and outside of the appliance with luke warm water and a mild soap or detergent. Abrasive 

or corrosive cleaning agents, steel wool, scouring sponges, or chemical cleaning agents should 

not be used under any circumstances. A sponge, soft brush or towel is recommended. After clean-

ing, thoroughly rinse and dry. You may want to leave the doors open allowing the compartments 

to ventilate for 20-30 minutes to get rid of residual odors. Check with your local Environmental 

Agency for recommendations on recycling packaging materials in your area.

POSITIONING THE APPLIANCE

The area in which the freezer is to be installed must be relatively cool, dry, and suitably ventilated. 

The area must be protected against any inclement weather (rain, snow) and excessive surface dust.  

To ensure proper function, the appliance must be placed on a flat, firm, and stable surface resting 

level on all four supports. The floor must be strong enough to support a fully loaded cabinet. Use 

wood or metal shims to level the freezer if necessary. Do not place the appliance in direct sunlight 

or near sources of heat, such as a stove or heater, as this can increase electrical consumption. Ex-

treme cold ambient temperatures may also cause the appliance to perform improperly.

Do not place the freezer close to heat sources (heater, stove, boiler, chimney, etc.), and avoid pro-

longed exposure to direct sunlight. This appliance uses the exterior walls to transfer heat from the 

inside of the cabinet. Ensure that there is adequate space between the freezer and neighboring 

walls or large objects. 

A minimum spacing of 3 inches (7.6 cm) is highly recommended.

 This will 

provide sufficient airflow around the appliance resulting in more efficient operation and longer ap-

pliance lifetime. Always keep the air vent openings of the compressor housing cover free from dust 

and obstructions. This appliance is intended for free-standing installation only and is not intended 

to be built into a cabinet or counter. 

INSTALLATION

• This appliance is heavy. Care should be taken when moving it.

• Be sure that the appliance does not stand on the electrical supply cable. Also, be sure the electri-

cal cable is not squeezed or bent when the appliance is being installed or moved.

• Do not install the appliance near water, for example in a wet basement or near a sink.

• Installation work and adjustments on the appliance must be carried out by qualified personnel 

only. Work performed by persons with inadequate technical knowledge may adversely effect the 

performance of the appliance, causing damage to the equipment, and void the warranty.

• It is dangerous to make alterations or attempt to modify this product in any way.  Product alter-

ations will void the warranty.

USE

• This appliance is intended for household use only. It is not designed for outside installation, in-

cluding anywhere that is not temperature controlled (garages, porches, vehicles, etc.).

• Do not store any containers with flammable vapors or liquids in or around the appliance, such as 

organic solvents, spray cans, gas cans, etc. Danger of explosion!