7
“Start-Up” Procedure
Electronic Ignition (battery)
1.
To start the refrigerator, turn the thermostat knob
E
to the maximum setting, #4.
2.
Turn button
G
to “Gas” position, then push
B
button in first and hold, proceed to
push in and hold the
D
button until you see the needle on the flame sensor
C
moving from the red into the green area. Release the
B
button, while continuing to
hold in the
D
button for an additional 10-15 seconds, now release the
D
button.
The burner should now stay on indicated by the needle staying in the green area, if
not repeat the lighting instructions above.
3.
Adjust the thermostat knob
E
to desired temperature setting after 8 or more
hours of operation.
4.
To change the battery in the electronic ignition, turn the far left knob
A
to the
left to expose the battery, remove AAA battery and replace with a new one,
positive outwards, replace the knob by turning to the right to close.
Shut Down Procedure – Gas Operation
1.
Turn selector knob
G
to the
OFF
position
2.
Shut the gas off at the LP-gas supply cylinder when the appliance is not in use.
3.
If the refrigerator will not be in operation for a period of weeks, it should be
emptied, defrosted, cleaned and the door left open.
110V Operation
1.
Ensure the electrical cord is plugged into a grounded outlet
2.
Turn the selector switch
G
to AC position, AC power indicator
F
will
illuminate
3.
To start the refrigerator, turn the thermostat knob
E
to the maximum setting.
4.
Adjust the thermostat knob to desired temperature setting after 8 hours of
operation.
CONTROLS –
See Fig. #5 for a description of controls
