U G P - 1 8 F
25
Step A: Wall Alignment
Step B: Alarm Activation Step C: Removal and Installation
6.3
To insure aesthetic alignment of the alarm with the hallway or wall, the
UP arrow on the mounting plate must be vertical when wall mounting:
(See Step A in Figure 2)
6.4 As described in Figure 2, attach the mounting plate on the wall. Use the
screws and anchors provided to secure the mounting plate.
6.5
The battery is INSTALLED REVERSED FOR SHIPPING. Remove and
reinstall the battery in the correct orientation as noted on the inside of
the battery door. When installing the battery, align the “+” and “-“
battery terminals on the correct contacts. The alarm will beep once
indicating proper battery installation.
WARNING
: Battery is required for operation of appliance, alarm
operation and detection of carbon monoxide. If no battery is installed,
the appliance will not stay lit. The battery door will not close easily and
the unit will not attach to the mounting bracket.
6.6 Twist the alarm in the direction indicated by the “ON” arrow on the
alarm cover (see step D) until it locks in place.
6.7 To make your carbon monoxide alarm tamper resistant, a locking pin has
been provided in the bag with the screws and anchors. Using this pin
will deter children and others from removing the alarm from the
mounting plate. To use the pin insert it into the hole in the side of the
alarm after the alarm has been installed on the mounting plate (See
Figure 2: Installation Instructions
