U N I Q U E U G P 2
9
electronic ignition
C
discharges sparks onto the burner when the button is pushed.
See
Figure #1
1.
“MAX” Setting of the Thermostat:
In gas operation, the thermostat allows the
burner to remain on high flame continuously. (turn clockwise), and in 110V
operation the element will stay on until the desired temperature is reached inside
the freezer.
2.
The thermostat can be adjusted between “4” and “1” to obtain the desired
freezer temperature. When the thermostat reaches the set temperature, it will
reduce the burner back to bypass operation or shut the element off in 110V
operation.
3.
In DC operation the freezer will only maintain the temperature that’s already
been achieved.
There is no thermostatic function.
How to Use the Freezer
This compartment is not designed for deep or quick freezing of food. To prevent food
from drying out, keep it in covered dishes, containers, plastic bags or wrapped in
aluminum foil.
Defrosting
Frost will gradually accumulate inside the freezer surfaces. It must not be allowed to grow
too thick as it acts as an insulator. Check the formation and when it exceeds ½” thick,
defrost the freezer.
Shut off and empty the freezer, leaving the freezer lid open.
DO
NOT
USE A HOT AIR BLOWER
,
PERMANENT DAMAGE
COULD RESULT
.
DO
NOT
USE A KNIFE
,
ICE PICK
,
OR ANY
OTHER SHARP TOOLS TO REMOVE FROST FROM THE FREEZER
COMPARTMENT
.
When all frost is melted in the freezer it should be wiped up with a clean cloth. Replace
all frozen food and set the thermostat to its Max position.
Cleaning
Cleaning the freezer is usually done after it is defrosted or put into storage. To clean the
interior liner of the freezer, use a lukewarm water and weak soda solution.
