42
CARE AND MAINTENANCE
(continued)
REPLACING THE OVEN LIGHT
• Let the oven cavity and broil burner cool down.
• Switch off the electric supply.
• Remove the protective cover.
• Unscrew and replace the bulb with a new one suitable for high temperature
(200°~ 500°F) having the same specifications: E14 120V 25W 300°C.
• Replace the protective cover.
NOTE:
Oven bulb replacement is not covered by your guarantee.
LEVELING THE RANGE
The range must be level to obtain proper operating. The four screws type
leveling legs located on the corners at the bottom of range should be adjusted
by turning them clockwise to make the range higher or counter-clockwise to
lower the range until the range is level. Use a level on surface units to check
the leveling of the range.
ANTI-TIP BRACKET INSTALLATION
To reduce the risk of tipping the range by abnormal usage or improper door
loading, the range must be secured by properly installing the anti-tip device
packed with the appliance.
• Place the anti-tip bracket on the floor as shown figure. Anti-tip bracket can be
installed on the right and left side.
• Make the locations of 2 (x2) holes of ant-tip bracket on the floor.
• Use a drill bit
• Secure bracket to floor using screws supplied.
• Slide appliance into position.
NOTE:
If range is
relocated, the bracket
must be removed and
installed in new location.
Summary of Contents for UGP-24CR W
Page 21: ...21 WALL CLEARANCES continued...
Page 45: ...45 24 WIRING DIAGRAM...
