2
Tools required
Robertson
Screwdriver
‐
Green
#1
(burner
box
screws)
12
mm
wrench
–
removes
thermocouple
from
bracket
if
required
13
mm
wrench
‐
removes
older
style
orifice
from
check
point
body.
10mm
wrench
‐
removes
new
style
orifice
from
check
point
body.
Adjustable
wrench
–
holds
check
point
body
in
place
while
removing
orifice.
Shut off the gas supply at the gas line.
Unhook fridge from the gas line and cap the
line for safety reasons.
Unhook the venting and pull the fridge away
from the wall and gently lay the fridge down
on its face using a thick blanket or a piece of
foam to reduce scratches.
You can also
work on the appliance standing up.
With the fridge lying on its face, walk
around to where the bottom of the fridge is
and look towards the right side for a small
silver box known as the “burner box”.
1.
Remove the cover as shown using Robertson #1
screwdriver. Removing 4 screws on the front
and 4 screws at the underside of the box.
2.
Remove orifice with 13 mm wrench – use back
up wrench on check point body located at left
side of burner box.
UNIQUE
UGP6C/8C/10C
Direct
Vent
Orifice
Cleaning
Instructions
Remove 4 screws at the
front of the burner box
Also remove 4 screws at the
underside of the burner box
Remove orifice
Old
style
orifice
Remove orifice
New
style
orifice
