UNISENSE MultiChannel UniAmp, User Manual

16

ASSEMBLY PROCEDURE 3D MOTORIZED SYSTEM

(BEFORE NOVEMBER 2023)

1 ⸀  Mount the 3D arm on the vertical post of the Laboratory Stand ⸀ To do 

this, put the aluminium 昀椀nger bolts into the holes on the 3D arm and 

mount the elongated nuts by one to two rounds ⸀ Slide the nuts into 
the groove of the stand ⸀ Position the arm horizontally and tighten the 

aluminium 昀椀nger bolts well with the provided tool. 

2 ⸀ 

Mount the 昀椀rst Motor Stage (MMS) on the 3D arm using 

4 of the long 4 mm bolts ⸀ Move the moving stage on the 
MMS to one side by rotating the spindle by hand ⸀ This 

will expose two of the 昀椀xing holes (see picture). Mount 

the 2 bolts and move the moving stage to the other 

side to expose the other two 昀椀xing holes and mount 

the bolts ⸀ 

3 ⸀ 

Mount the 3D angle on the 昀椀rst MMS. This is 昀椀xed 

using two 6 mm bolts as indicated in the picture ⸀ 

4 ⸀  Mount the second MMS on the 3D angle using 

two long 4 mm bolts (see picture) ⸀ Make sure the 
second stage is horizontal and tighten the bolts 
well ⸀

3D Arm

Moving stage

Fixing holes

Spindle

Fixing holes

3D Angle

Fixing holes