Digital Network Video Surveillance System
Alarm
Please refer to chapter 4.6 Alarm Setup and Activation.
Detect
Please refer to chapter 4.5 Detect.
Pan/Tilt/Zoom
The pan/tilt/zoom setup includes the following items. Please select channel first. See Figure 5-34.
Protocol: Select corresponding PTZ protocol such as PELCOD.
Address: input corresponding PTZ address.
Baud rate: Select baud rate. The default value is 9600.
Data bit: Select data bit. The default value is 8.
Stop bit: Select stop bit. The default value is 1.
Parity: The default value is none.
After completed all the setups please click save button, system goes back to the previous menu.
For detailed setup, please refer to chapter 4.9 preset/patrol/pattern/scan.
Figure 5-34
Display
Display setup interface is shown as below. See Figure 5-35.
Transparency: Here is for you to adjust transparency. The value ranges from 128 to 255.
Channel name: Here is for you to modify channel name. System max support 25-digit (The value may
vary due to different series). Please note all your modification here only applies to DVR local end. You
need to open web or client end to refresh channel name.
Time display: You can select to display time or not when system is playback.
Car number display: You can select to display plate number or not when system is playback.
GPS display: System displays GPS information in the screen for your reference.
Please note only the
unit of GPS module supports this function.
Unisight Digital Technologies, Inc.
71
